AD5803 - Fourth Print

The fourth print has been very straightforward to produce, since it had the same lighting of the first print I made.

However, I made two test prints before printing the whole sheet.

Unfortunately, there was a clear mark on the print. I checked the negative, but it was fine so it must have been a mark on the paper and I printed again.

When I was checking if I could see any mark in the projected negative, I turned off the red filter and by mistake I forgot to turn it on again when I printed.

So by mistake I made a print without the red filter. It is interesting to see how the same settings without any filter, change completely the aesthetic of the image.

This is the final print:

I used the following settings:

Paper: Resin coated

Aperture: f11

Exposed: 9s

Filter: Magenta 4.5